| Have a member of staff responsible for checking all utility bills – Make sure they know how the bills are calculated, what tariffs are available, etc. |
|
| Carry out your own readings of all energy and water meters each month – Use the information to plot patterns of use |
|
| Check that all utility bills are accurate and that any estimates are reasonable – Even the largest utility companies make mistakes |
|
| Annually review the tariffs you use – Not only do your usage patterns change, your suppliers also change the deals they offer |
|
| Monitor overnight energy usage – Check if it is being used by essential equipment and if so that you have the best overnight tariff |
|
| Make the best use of cheap rate electricity – If you can arrange usage by water heaters etc so that 15% of total electricity usage occurs during off–peak hours, you might benefit from switching to a day/night tariff |
|
| If you are on a Maximum Demand tariff, review your supply capacity – If your declared supply capacity is more than 15% higher than your highest Maximum Demand, contact your supplier to have it lowered |
|
| Find ways to reduce usage during peak hours – Try rescheduling non–essential loads |
|
| If you are on a monthly tariff, check your power factor – Check that you are not being penalised for a poor power factor |
|
| Shop around for a cheaper electricity and/or gas supplier – Find out more at http://www.ukenergywatch.org/ |
|
| If your site has more than one gas meter, make sure they are aggregated for billing purposes – This can reduce both standing and unit charges and could lead to a better rate |
|
| Make sure your water meter is the right size – Standing charges are calculated according to meter size – don't pay for an unnecessarily large one |
|